Clear-Tite Contact Cement
When the job gets hot, Clear-Tite stays stuck.
Clear-Tite Contact Cement
It takes a special adhesive to hold fast when the temperature goes up.
- Bonds vinyl laminates, flooring, and carpeting
- Repairs seat covers, weather stripping and loose flooring
- Provides a high-strength bond resistant to liquids and heat
- Sets on contact to eliminate the need for clamping
- All 4 oz. through 32 oz. cans come with a brush-cap top
*Please note that this adhesive is light beige in color – it does not dry clear.
Looking to buy in bulk? Please contact [email protected] for more information on purchasing case lot quantities.
This product is eligible for special wholesale pricing. Contact us at 978-897-8000 or [email protected] to learn more!
It takes a special adhesive to hold fast when the temperature goes up.
And Clear-Tite is a special adhesive. Developed to hold fast at temperatures of up to 250°F, it’s the clear choice for installations where a hot pan, a warm oven or a steamy faucet might cause lesser glues to soften.
Maybe that’s why Clear-Tite has been the clear choice for more than 40 years for everything from tile and linoleum to cabinets, countertops, glass, carpeting and more. It leaves your installation flawless – even when the heat is on.
Used in the manufacture of kitchen cabinets, countertops, desktops, tabletops, store fixtures, and hard orthotics.
Compatible Materials: Canvas, Carpeting, Ceramics, Concrete, Cove Base, Crepe Rubber, Fiberglass, Foam (EVA, Nitrile, Vinyl), Formica, Glass, Leather, Metals, Neoprene, Particle Board, Some Plastics, Tile
CA PROP 65 WARNING: This product can expose you to toluene, which is known to the State of California to cause birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.
General Instructions
Shake can well before use.
- Clean surfaces with alcohol or compatible solvent.
- Sand any glossy surfaces lightly.
- Apply an even coat to both surfaces to be joined.
- Allow cement to set until tacky, typically around two minutes. Cement will remain tacky for around thirty minutes.
- Press together while tacky. Available for use within minutes, as full-strength bond forms quickly.
- Remove any excess adhesive.
Use RH Thinner for preparation and cleanup.
Apply within 18 months of manufacture for best results.
Documents
Spec Sheets
Safety Data Sheets
Regulatory Declarations
Technical Data
- Base: Neoprene Resin
- Solvents: Heptane, Acetone, Toluene, Methyl Ethyl Ketone (MEK)
- Color: Beige
- Viscosity: Low, 750-900 cps at room temperature
- Application: Brush, Roller, Notched Trowel, Squeeze Bottle
- Solids: 21% ± 1% (approx.)
- Net Weight: 7.2 lbs./gallon (approx.)
- Application Temperature Range: 35° F to 95° F
- Service Temperature Range: -30° to 250° F
- Flash Point: 17° F
- Shelf Life: 18 months from date of manufacture
- Tack Time: 2 to 10 minutes
- Coverage: 1 oz./sq. ft. (bonded area)
CA PROP 65 WARNING: This product can expose you to toluene, which is known to the State of California to cause birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.
Featured Applications
You may also like…
Find the Right Glue
RH Adhesives products are available both globally and right here on our website. You can order directly from our factory in Acton, Massachusetts or through a local distributor or reseller near you.
For larger-sized quantities sold by the case, contact us and a sales representative will be happy to assist you.