HH-66 Thinner

Our HH-66 Thinner is designed primarily for use with HH-66 Vinyl Cement.

  • Formulated specifically for use with HH-66 Vinyl Cement
  • Designed for thinning, spraying, reactivating, prepping, and cleaning your project and tools

For thinning or spraying our adhesives, we recommend adding drops of thinner as needed - up to (but not more than) 20% thinner. Tips for spraying our adhesives can be found here.

SKU: N/A Category:

Looking to buy in bulk? Please contact [email protected] for more information on purchasing case lot quantities.

This product is eligible for special wholesale pricing. Contact us at 978-897-8000 or [email protected] to learn more!

Our HH-66 Thinner is designed primarily for use with HH-66 Vinyl Cement.

This solvent-based thinner reactivates dried HH-66 Vinyl Cement or removes unwanted HH-66 from surfaces.

You also can use HH-66 Thinner to clean brushes, rollers, spray guns, and other types of applicators.  Since HH-66 Thinner is flammable, it should be used in a well-ventilated area.  Handle empty containers with care, as any residual solvent is flammable.

HH-66 Thinner Application Instructions

Use a brush or roller to apply a light layer of the appropriate HH-66 Thinner directly to the application.  Bond the pieces together as per the adhesive directions.

Add up to 20% HH-66 Thinner until the original consistency is reached.  Mix until evenly dispersed.

Follow the manufacturers’ recommended cleaning procedure.  It is recommended to clean the applicator immediately after use.  HH-66 Thinner is flammable and should be used in a well-ventilated area.  Handle empty containers with care as residual solvent is flammable.

Add HH-66 Thinner as needed (up to 20% thinner).  Mix until evenly dispersed.  Over-dilution can cause loss of bond strength.  A second application may be required to achieve the appropriate coverage for a good bond.

Usefulness depends on the sprayer and application.  It is not recommended to use more than 20% thinner for spraying.  With diluted adhesive, a second application may be required to achieve the appropriate coverage for a good bond.

Documents

Spec Sheets

Safety Data Sheets

Technical Data

  • Base:  Methyl Ethyl Ketone (MEK), Acetone, Toluene
  • Color:  Clear
  • Viscosity:  1 cP (water-like) at room temperature
  • Application:  Brush, roller, spray gun, or mix into cement
  • Vapor Density:  Heavier than air
  • Relative Density:  Lower than water
  • Temperature Limit:  95° F
  • Flash Point:  12° F
  • Shelf Life:  18 months from date of manufacture
  • Coverage:  Varies

NOTE:  May adversely affect some plastics and other materials.  Test first.

Copyright 2024 - RH Adhesives. All Rights Reserved.